SIIG Serial ATA 4-Channel RAID Przewodnik Instalacji Pobierz pdf (Strona 5)

Note: If it is your desire to monitor disk activity of

the Serial ATA hard drives, you may at this time

connect the hard disk LED of the system case to the

Hard Disk LED Pins on the Serial ATA controller,

see Board Layout on page 2 for the location of the

pins. All four Serial ATA Connectors activate the

LED. For most systems connect the Red wire to the

pin farthest from the mounting bracket.

6. Replace the computer cover and reconnect the

power cord. Go to RAID Arrays to configure the

RAID BIOS.

RAID Arrays

RAID Arrays are setup in the Serial ATA 4-Channel RAID's

BIOS. Find your RAID set from the table of contents.

Follow the steps in the order in which they appear.

Table of Contents

RAID 0 (striping) ...........................................page 6-7

RAID 1 (mirroring)........................................page 7-9

RAID 0+1 (mirror+striping) ....................page 10-11

Deleting RAID Arrays ................................... page 12

Resolving Conflicts........................................ page 12

Low Level Format.......................................... page 12

1 2 3 4 5 6 7 8 9 10 ... 33 34

Brak uwag

SIIG Serial ATA 4-Channel RAID Przewodnik Instalacji Strona 5