SIIG Serial ATA 4-Channel RAID Przewodnik Instalacji Pobierz pdf (Strona 11)

2. At the next screen select Create RAID Set, then

press Enter.

3. Select RAID10 then press Enter.

4. Select Auto configuration, then press Enter.

5. When asked Are You Sure (Y/N)?, press Y to accept.

6. Press Ctrl+E to exit the BIOS.

7. When asked Are you sure to exit (Y/N)?, press Y to

exit and reboot.

8. Continue with Fdisk and Format steps as if you

were installing a conventional hard drive.

Rebuilding a Failed RAID 0+1 Set

When a failure to one member occurs, you will be notified

either by the RAID BIOS during boot or by the SATA

Raid GUI while in Windows. The steps below will guide

you in rebuilding a failed RAID 0+1 set.

1. Replace the failed drive(s) with one of equal or

greater capacity, then start the computer.

2. During boot press Ctrl+S or F4 to enter the RAID

BIOS.

3. Select Create RAID set then press Enter.

4. Select SPARE DRIVE then press Enter.

5. Select the replacement drive then press Enter.

6. When asked Are You Sure (Y/N)?, press Y to confirm.

7. Press Ctrl+E to exit.

8. When asked Are you sure to exit (Y/N)?, press Y to

exit.

Note: If during restart the RAID BIOS reports an

incomplete RAID set, disregard the message,

continue booting, and let the Mirror rebuild.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 33 34

Brak uwag

SIIG Serial ATA 4-Channel RAID Przewodnik Instalacji Strona 11