SIIG Serial ATA 4-Channel RAID Przewodnik Instalacji Pobierz pdf (Strona 18)

Windows 2000

A new installation of Windows 2000 requires a floppy

disk for the driver installation. To make this floppy disk,

copy the contents of the Floppy folder, found on the

driver CD, onto a blank floppy disk then follow the

directions below.

For A New Installation

Important: During Windows 2000 installation you will

be asked to restart several times. If during any restart the

RAID BIOS reports an incomplete RAID set, disregard

the message, continue with the installation, and let the

Mirror rebuild on its own. This shouldhappen only once

and it's done automatically. Please do not interfere this

process by re-configuring the RAID sets.

1. Setup the RAID array prior to Windows installation.

2. Follow Microsoft's Windows 2000 installation

procedure.

3. Restart the computer when prompted by the

installation.

4. At the Windows 2000 Setup screen, press F6.

5. When prompted press S to specify the location of

the driver.

6. Insert the driver diskette, then press Enter.

7. Select Silicon Image Sil 3x14 SATARaid Controller

for Windows NT 4.0 and 2000, then press Enter.

8. Press Enter to finish driver installation, then follow

the on-screen instructions to complete the

installation.

When Windows installation completes, go to SATARaid

GUI on page 22 and install the RAID monitoring utility.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 33 34

Brak uwag

SIIG Serial ATA 4-Channel RAID Przewodnik Instalacji Strona 18