SIIG Serial ATA 4-Channel RAID Przewodnik Instalacji Pobierz pdf (Strona 3)

Hardware Installation

General instructions for installing the card are provided

below. Since the design of computer cases and

motherboards vary, refer to your computer’s reference

manual for further information, if needed.

Static Electricity Discharge may permanently damage

your system. Discharge any static electricity build up in

your body by touching your computer’s case for a few

seconds. Avoid any contact with internal parts and

handle cards only by their external edges.

1. Turn OFF the power to your computer and any

other connected peripheral devices.

2. Unplug the power cord from the back of the

computer.

3. Remove your computer’s cover.

4. Remove the slot bracket from an available PCI slot.

5. To install the card, carefully align the card's bus

connector with the selected PCI slot on the

motherboard. Push the board down firmly, but

gently, until it is well seated.

6. Replace the slot bracket's holding screw to secure

the card.

7. Now go to Device Connection to connect your

Serial ATA hard disk drives.

Device Connection

The Serial ATA 4-Channel RAID is a four channel Serial

ATA controller that supports up to four Serial ATA hard

disk drives. It is recommended to use identical hard

drives for all RAID configurations, however, it's possible

to combine hard drives of different sizes and makes.

1. Install your hard disk drive(s) in chassis.

1 2 3 4 5 6 7 8 ... 33 34

Brak uwag

SIIG Serial ATA 4-Channel RAID Przewodnik Instalacji Strona 3