SIIG Serial ATA 4-Channel RAID Przewodnik Instalacji Pobierz pdf (Strona 15)

For An Existing Installation

1. Setup the RAID array prior to driver installation and

boot up to Windows.

2. At the Add New Hardware Wizard, insert the driver

CD.

3. Select Automatic search for a better driver

(Recommended), then click Next.

4. Accept the default entry then click OK.

5. Click Finish.

6. Remove the driver CD and restart Windows to

complete the installation.

When Windows resumes, go to SATARaid GUI on page

22 and install the RAID monitoring utility.

To Verify Installation In Windows 98SE/ME:

1. Right click My Computer and click Properties.

Select Device Manager tab.

2. Double click SCSI Controllers, Silicon Image Sil

3x14 SATARaid Controller is listed.

3. Highlight Silicon Image Sil 3x14 SATARaid

Controller and click Properties. If any error message

is displayed, remove Silicon Image Sil 3x14

SATARaid Controller listing, restart Windows and

reinstall the drivers.

Windows NT 4.0

A new installation of Windows NT requires a floppy disk

for the driver installation. To make this floppy disk, copy

the contents of the Floppy folder, found on the driver CD,

onto a blank floppy disk then follow the directions below.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Brak uwag

SIIG Serial ATA 4-Channel RAID Przewodnik Instalacji Strona 15