SIIG Serial ATA PCI RAID Instrukcja Użytkownika Pobierz pdf (Strona 23)

User's Manual

2-12

7. Press Y to copy from the Source to the Destination

drive.

8. Press N to Offline copy.

9. Answer Y to Enable Auto-Rebuild.

10. When asked Are You Sure?, press Y to accept.

11. Press ESC to exit the RAID BIOS utility. Ignore the

BIOS error message and continue booting. The mirror

rebuilds automatically.

2-3.4 RAID 0+1 (mirror-striping)

This RAID set is used on New/Blank hard drives, do not use

this on an existing Windows installation. To create a Mirror-

Striping set four hard drives are required.

1. As the BIOS boots press F3 when prompted to enter

the UltraATA 100 RAID BIOS utility.

2. At the next screen press F2 to form a RAID set.

3. Press F3 to create RAID 0+1.

4. Choose the chunk size by pressing the appropriate

number key (64 is recommended).

5. Enter the first Source drive, then enter the second

source drive.

Note: To optimize performance, configure both source

drives to be from different channels and configure both

destination drives to be from different channels.

6. Enter the first destination drive, then enter the second

destination drive.

7. Enter Y to accept the RAID configuration.

8. On the following screen press ESC to exit the RAID

configuration utility and reboot the computer.

9. Continue with Fdisk and Format steps as if you were

installing a conventional hard drive.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 53 54

Brak uwag

SIIG Serial ATA PCI RAID Instrukcja Użytkownika Strona 23