SIIG Serial ATA PCI Przewodnik Instalacji Pobierz pdf

Serial ATA PCI

Quick Installation Guide

04-0265C

Introducing the Serial ATA PCI

The Serial ATA PCI is an ultra high-speed dual channel

Serial ATA controller board for use in Pentium-class

computers. It achieves burst data transfer rates up to

150MB/s (1.5Gb/s) and supports various brand of hard

disk drives with capacities greater that 137GB.

Features and Benefits

• Compliant with Serial ATA Specification, rev. 1.0

• Compliant with PCI Specification, rev. 2.2

• Provides two independent channels to support up

to two Serial ATA drives.

• Features independent 256-byte FIFOs per channel

for host reads and writes

• Co-exists with on-board Ultra ATA controller

• Features Watch Dog timer for fault resiliency

• Supports 32-bit wide PCI bus at 66MHz

• Lower pin count and voltage requirement, plus

better cabling over traditional Parallel ATA make

Serial ATA the controller of the future

System Requirements

• Pentium-class computer with one available PCI slot

• Windows 98/98SE/ME/NT 4.0/2000/XP

1 2 3 4 5 6 ... 11 12

Podsumowanie treści

Strona 1 - Quick Installation Guide

1Serial ATA PCIQuick Installation Guide04-0265CIntroducing the Serial ATA PCIThe Serial ATA PCI is an ultra high-speed dual channelSerial ATA controll

Strona 2 - Hardware Installation

10Note: When the Software Installation warningpops up, click Yes. And when the HardwareInstallation warning pops up, click Yes again. Ourdriver has

Strona 3 - Device Connection

11Technical Support and WarrantyQUESTIONS? SIIG’s Online Support has answers!Simply visit our website at www.siig.com and click on Support.Our online

Strona 4 - Driver Installation

Serial ATA PCI is a trademark of SIIG, Inc.SIIG and SIIG logo are registered trademarks of SIIG, Inc. Microsoft and Windows areregistered trademarks

Strona 5 - Windows 98/98SE

2Package Contents• Serial ATA PCI adapter• Driver diskette• Serial ATA cable• Serial ATA power cable• This quick installation guideBoard LayoutCN1CN2S

Strona 6 - Windows ME

31. Turn OFF the power to your computer and anyother connected peripheral devices.2. Unplug the power cord from the back of thecomputer.3. Remove your

Strona 7 - Windows NT4.0

4Figure 3. Connecting the Serial ATA cable5. Follow the same instructions when connecting asecond hard drive. Device connection is nowcomplete.6. Re

Strona 8 - Windows 2000

5Windows 98/98SEFor New Windows 98 Installation1. Install the board and follow Microsoft procedures toinstall Windows 98 accordingly.2. Once Windows h

Strona 9

6Windows MEFor New Windows ME Installation1. Install the board and follow Microsoft procedures toinstall Windows ME accordingly.2. Once Windows has be

Strona 10 - Bios Configuration

7Verify Windows 98/ME Installation1. Right-click My Computer, then click Properties.Select Device Manager tab.2. Double click SCSI Controllers and Sil

Strona 11

84. Insert the driver diskette, type in A:, then click OK.5. Highlight Silicon Image SiI 3112 ... Controller andclick OK.6. Click OK, remove the drive

Strona 12 - About SIIG, Inc

9For Existing Windows 2000 Installation1. Install the board and boot up Windows 2000.2. At the Found New Hardware Wizard, click Next.3. Select Search